1. The tire must install in the stipulation vehicle type, conforms with the request and on the size match case wheel felloe.
2. On the identical car axle should assemble the identical specification, the trade mark, the size, the level, the barometric pressure, the pattern tire
3. When installs with the new embryo, best entire Che Huantai. Otherwise, the new embryo should install in the front wheel and in the hind axle outside files.
4. When the hind axle dual tire and installs, the dual tire gap does not have to be smaller than 20 millimeters, but also should not big �? 5 millimeters, the wheel felloe, the wheel rim, the wheel drum, the vent should aim.
5. When assembly direction detection pattern tire, should cause the tire the hand of rotation mark to be consistent with the automobile advance travel direction. When assembly direction detection pattern tire vehicles frequently when hard base road surface travel, may use the front wheel reverse attire, reduces the rolling resistance, saves the fuel.
6. Installs the tire must gasify on the automobile, when stops using the time surpasses above a week should the frame go against, moreover the automobile must park in the garage or parks in the hiding place, avoids the sunlight perpendicular incidence, prevents the tire surface crack.
7. The tire according to pigeonholing inflating in the standard, but join one degree of long-distance vehicles which exceeds 4 areas on the road surface, front wheel and behind interior wheel to be constant standard pigeonhole last 0.2-0.3kgf/cm2.
8. While driving a vehicle in long distance, should often check the atmospheric pressure, while pressing and exceeding original standard 1kgf/cm2 while finding, should park to have a rest in the covered place, continue going after pressing and dropping to appropriately in waiting. Inflammation goes and should be paid special attention to in festival in summer.
9." inflate more in winter ", " inflate few in summer " or the method of " going and bleeding midway " can't be adopted absolutely.
10. Tire loading, depending on the peak load that the single fetus stipulates is a standard, mustn't overload, should be distributed evenly.
11. The car should reduce the speed to go on the bad and way type complicated road. Start, park, upper and lower slope, turn, cross rut and should reduce speed especially at the rail, should guide the car to the road besides knowing the car to go while going on the joining type road surface, avoid receiving strength unilaterally.
12. According to the experiment materials, the wearing and tearing of the car front wheel tire is lower than the rear wheel 20-30, in order to lengthen the service life of the tire, while going 8000-10000 kilometers each time, should replace the law to replace according to the regulation. Should foreign fetus, inner tube of a tyre, cushion bring conduct comprehensive review into at the same time.
13. Must carry on all tires at the same time while changing the position of a foetus, notice that does not alter the rolling in the direction originally of this tire. 14. After the car rests under the climate of severe cold for a long time, the temperature of the tire is low when defeated by 30-40 ℃, it must be steady to start and start again, within initial 20-30 minutes, must go with 5-7 kilos per hour of paces, after the tire intensifies, and then go at the ordinary pace.
15. While refitting the carriage or change wheelbase or increasing the fittings, must consider the load of each tire of front and back axle is distributed, so as not to cause some tires to overload.
16. When the wheel uses the tyre chain, it through after the difficult location, remove immediately to want use of both sides. Tyre chain if high strung that load with or pass loose to can damage tire fetus side, and the child.
17. Should often check the appearance of the tire and find there is breach, sting the hole etc. while damaging, should mend immediately, in case that the wound is expanded.
18. The cover tyre is put in the standard rim, must keep intact to the edge of rim (or trivial ring) at the same time, should also eliminate rust and add and scribble and antirust oilily regularly.
Tire use matters needing attention
1. The tire must install in the stipulation vehicle type, conforms with the request and on the size match case wheel felloe.
2. On the identical car axle should assemble the identical specification, the trade mark, the size, the level, the barometric pressure, the pattern tire
3. When installs with the new embryo, best entire Che Huantai. Otherwise, the new embryo should install in the front wheel and in the hind axle outside files.
4. When the hind axle dual tire and installs, the dual tire gap does not have to be smaller than 20 millimeters, but also should not big �? 5 millimeters, the wheel felloe, the wheel rim, the wheel drum, the vent should aim.
5. When assembly direction detection pattern tire, should cause the tire the hand of rotation mark to be consistent with the automobile advance travel direction. When assembly direction detection pattern tire vehicles frequently when hard base road surface travel, may use the front wheel reverse attire, reduces the rolling resistance, saves the fuel.
6. Installs the tire must gasify on the automobile, when stops using the time surpasses above a week should the frame go against, moreover the automobile must park in the garage or parks in the hiding place, avoids the sunlight perpendicular incidence, prevents the tire surface crack.
7. The tire according to pigeonholing inflating in the standard, but join one degree of long-distance vehicles which exceeds 4 areas on the road surface, front wheel and behind interior wheel to be constant standard pigeonhole last 0.2-0.3kgf/cm2.
8. While driving a vehicle in long distance, should often check the atmospheric pressure, while pressing and exceeding original standard 1kgf/cm2 while finding, should park to have a rest in the covered place, continue going after pressing and dropping to appropriately in waiting. Inflammation goes and should be paid special attention to in festival in summer.
9." inflate more in winter ", " inflate few in summer " or the method of " going and bleeding midway " can't be adopted absolutely.
10. Tire loading, depending on the peak load that the single fetus stipulates is a standard, mustn't overload, should be distributed evenly.
11. The car should reduce the speed to go on the bad and way type complicated road. Start, park, upper and lower slope, turn, cross rut and should reduce speed especially at the rail, should guide the car to the road besides knowing the car to go while going on the joining type road surface, avoid receiving strength unilaterally.
12. According to the experiment materials, the wearing and tearing of the car front wheel tire is lower than the rear wheel 20-30, in order to lengthen the service life of the tire, while going 8000-10000 kilometers each time, should replace the law to replace according to the regulation. Should foreign fetus, inner tube of a tyre, cushion bring conduct comprehensive review into at the same time.
13. Must carry on all tires at the same time while changing the position of a foetus, notice that does not alter the rolling in the direction originally of this tire. 14. After the car rests under the climate of severe cold for a long time, the temperature of the tire is low when defeated by 30-40 ℃, it must be steady to start and start again, within initial 20-30 minutes, must go with 5-7 kilos per hour of paces, after the tire intensifies, and then go at the ordinary pace.
15. While refitting the carriage or change wheelbase or increasing the fittings, must consider the load of each tire of front and back axle is distributed, so as not to cause some tires to overload.
16. When the wheel uses the tyre chain, it through after the difficult location, remove immediately to want use of both sides. Tyre chain if high strung that load with or pass loose to can damage tire fetus side, and the child.
17. Should often check the appearance of the tire and find there is breach, sting the hole etc. while damaging, should mend immediately, in case that the wound is expanded.
18. The cover tyre is put in the standard rim, must keep intact to the edge of rim (or trivial ring) at the same time, should also eliminate rust and add and scribble and antirust oilily regularly. |
|
The tire maintains 
